I created two polyhedra that I think look very nice, and would like to create a compound of them. Is there any way to do so in Stella that I am unable to find, or some other tool I can use?New to Stella - is there a way to combine OFF files?
New to Stella - is there a way to combine OFF files?
Exactly what it says on the tin I created two polyhedra that I think look very nice, and would like to create a compound of them. Is there any way to do so in Stella that I am unable to find, or some other tool I can use?
I created two polyhedra that I think look very nice, and would like to create a compound of them. Is there any way to do so in Stella that I am unable to find, or some other tool I can use?-
robertw
- Site Admin
- Posts: 714
- Joined: Thu Jan 10, 2008 6:47 am
- Location: Melbourne, Australia
- Contact:
Re: New to Stella - is there a way to combine OFF files?
You can use the "Edit->Put Model in Memory" submenu to pick a slot to save it to (or keyboard shortcut "m"). Then load other model. Then combine them with "Edit->Add/Blend from Memory".
If they have the same symmetry, then they should align well. If not, your milage may vary.
If they have the same symmetry, then they should align well. If not, your milage may vary.