software3d.com Forum Index software3d.com
Software3D Forums
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

did you know these?

 
Post new topic   Reply to topic    software3d.com Forum Index -> Stella Forum
View previous topic :: View next topic  
Author Message
dysphras



Joined: 10 Jun 2008
Posts: 5

PostPosted: Thu Jun 12, 2008 8:52 am    Post subject: did you know these? Reply with quote

Slice (at 0.5) a 5-Hi (120-cell) with a hyperplane direction cell-1st. Do the same to a 6-Ex (600-cell), same depth but direction vertex-1st this time. Save the two slices (polyhedra) for comparing.
The 1st is the dual polyhedron of the latter and vice-versa. I've not gotten the exact same scale but the solid angles are equal & the scale factor between the two figures (better, between one figure and the dual of the other) is about 1.085.
But, pay attention, 5-Hi-0.5-V1st is *not* the dual of 6-Ex-0.5-C1st...
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    software3d.com Forum Index -> Stella Forum All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group
Protected by Anti-Spam ACP